TS-12 Musician’s Manual Section 7 — Effect Parameters
15
WIDTH Range: 00 to 99
Controls the depth of vibrato and tremolo.
REGEN Range: -99 to +99
Controls the amount of feedback applied to the chorus. The sign of the value determines the
polarity of the feedback. Feedback accentuates the complexity of the “swept” signal.
DECAY TIME Range: 0.20 to 100.0
Controls the amount of time it takes for the reverberation to decay to a low level (-60 dB) after the
input signal stops.
EARLY REF LEV Range: 00 to 99
Controls the level of pre-echoes of the input signal added directly to the reverb output.
HF - DAMPING Range: 00 to 99
Controls the rate of attenuation of high frequencies in the decay of the reverberation. As natural
reverb decays, some high frequencies tend to get absorbed by the environment. Increasing the
value of this parameter will filter out increasing amounts of high-frequency energy.
BANDWIDTH Range: 00 to 99
Acts as a low pass filter on the signal going into the reverb, controlling the amount of high
frequencies that will pass into the effect. The higher the setting, the more high frequencies are
allowed to pass.
LF DECAY Range: -99 to +99
Boosts or cuts the rate at which low frequencies will decay.
DIFFUSION Range: 00 to 99
Determines whether the early reflections will appear as a series of discrete echoes (lower values)
or will be more diffused (higher values).
DETUNE - RATE Range: 00 to 99
Controls the LFO rate of detuning incorporated within the reverb. Detuning creates a slight pitch
shift into the reverberated signal, giving it a more natural sounding decay by breaking up
resonant nodes.
DEPTH Range: 00 to 99
Controls the depth of the detuning, that is, how much the pitch will change. Low values yield a
metallic sound. Some voices sound best with very low values.
46 CHORUS + REVERB 2
This effect combines a four-voice chorus with a plate reverb, sporting superior randomization
and poly-phase interpolation. Assign a voice to FX-1 to get reverb after chorus, or use FX-2 for
reverb only.
CHORUS MIX Range: 00 to 99
Controls the Dry/Wet mix within the chorus itself.
RATE Range: 00 to 99
Controls the four rates of modulation of the delay time of the chorus. The delay modulation
produces vibrato and tremolo.
To Next Page
Loading...
Need help?
General
