EasyManuals Logo
Home>ENSONIQ>Synthesizer>TS-12

ENSONIQ TS-12 User Manual

ENSONIQ TS-12
445 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #174 background imageLoading...
Page #174 background image
TS-12 Musician’s Manual Section 7 — Effect Parameters
25
LEVEL Range: -48 to +24 dB
Sets the amount of boost or cut applied to the low shelving filter.
TREBLE FC Range: 01KHz to 15KHz
Selects the cutoff of the upper-frequency band high shelving filter.
LEVEL Range: -48 to +24 dB
Sets the amount of boost or cut applied to the high shelving filter.
53 PHASER + REVERB
A 12-pole phase shifter with reverb. Assign a sound to FX-1 for reverb after phase, to FX-2 for
just reverb, or to DRY to bypass the effect.
PHASER CENTER Range: 00 to 99
Controls the center of the phaser width.
RATE Range: 00 to 99
Controls the rate of modulation of the phaser poles.
WIDTH Range: 00 to 99
Controls the amount of modulation applied to phaser poles.
REGEN Range: -99 to +99
Controls the amount of feedback applied to the phaser. The sign of the value determines the
polarity of the feedback.
DEPTH Range: 00 to 99
Controls the depth of the notches created by the phasing.
DECAY TIME Range: 0.20 to 100.0
Controls the amount of time it takes for the reverberation to decay to a low level (-60 dB) after the
input signal stops.
EARLY REF LEV Range: 00 to 99
Controls the level of pre-echoes of the input signal added directly to the reverb output.
HF - DAMPING Range: 00 to 99
Controls the rate of attenuation of high frequencies in the decay of the reverberation. As natural
reverb decays, some high frequencies tend to get absorbed by the environment. Increasing the
value of this parameter will filter out increasing amounts of high-frequency energy.
BANDWIDTH Range: 00 to 99
Acts as a low pass filter on the signal going into the reverb, controlling the amount of high
frequencies that will pass into the effect. The higher the setting, the more high frequencies are
allowed to pass.
LF DECAY Range: -99 to +99
Boosts or cuts the rate at which low frequencies will decay.
DIFFUSION Range: 00 to 99
Determines whether the early reflections will appear as a series of discrete echoes (lower values)
or will be more diffused (higher values).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ENSONIQ TS-12 and is the answer not in the manual?

ENSONIQ TS-12 Specifications

General IconGeneral
BrandENSONIQ
ModelTS-12
CategorySynthesizer
LanguageEnglish

Related product manuals