Section 4 — Understanding Presets TS-12 Musician’s Manual
10
Using Effects With Performance Presets
All three tracks in each preset, and all twelve tracks in each sequence or song, share the same
effects algorithm and settings. The effects settings for each preset is inherited from the primary
(non-layered) selected sound, and any layered sounds in the preset will use that same effect. The
effects settings for each sequence or song are inherited from the current sequencer effect at the
time the sequence or song was created. If this effect is incompatible with other programs in the
preset, sequence or song, there are several options:
• set the effects bus routing to -DRY- for any of the programs that are incompatible
• set the effects bus routing to -AUX- for programs that you want to process separately by
sending them to the AUX Outputs
• change the preset/sequence/song effect to be something more suitable
When you press the Track Effects button from preset or sequencer mode, the first page that
appears is the Track Effects Bus Routing page. On this page you can override the normal effects
routing of the sound on each track. Subsequent sub-pages let you edit the effect for use in a
preset, sequence, or song; these pages are identical to the effects programming pages under the
Program Effects button. See Section 6 — Understanding Effects for more information on effect
selection and programming.
To Next Page
Loading...
Need help?
General
