Section 7 — Effect Parameters TS-12 Musician’s Manual
28
from the two discrete echoes has one level control. There is also an external Dry signal (not
shown) that goes directly from the input to the output. The EFFECT MIX FX-1 POST-DDL and
FX-2 DDL parameters can be routed into the effect with different Dry/Wet mixes.
TREMOLO RATE Range: 000 to 130
Sets the rate of modulation. Mid values create a faster wavering sound. When used in
conjunction with the S/H RATE parameter it can create some interesting staccato effects.
DEPTH Range: 00 to 99
Sets the depth of amplitude modulation.
S/H RATE Range: 000 to 100
Controls the sample rate of a sample and hold network applied to the LFO within the tremolo.
When in “Hold,” the effect will be to fix the instantaneous amplitude (if the depth is not 00). A
setting of 001 will have the largest space between holds. Lower settings create a staccato effect,
whereas higher values will increase the amount of samples, making the tremolo flow more
smoothly. This parameter can also be turned off (when set to 000).
L/R LFO Range: OUT-OF-PHASE or IN-PHASE
Controls whether the left and right channels of the stereo tremolo will modulate IN-PHASE or
OUT-OF-PHASE.
DELAY - REGEN Range: -99 to +99
Controls the amount of regen applied to the delay time taps. The sign of the value determines
the polarity of the regen. A value of +00 will eliminate the audible delay.
TIME (L and R) Ranges: 0000 to 1500 msec
These parameters control the time delays for the left and right channel regen delays, and has
nothing to do with the tremolo effect.
ECHO - LEVEL Range: 00 to 99
Controls the volume of the discrete echo for both the left and right sides.
TIME (L and R) Ranges: 0000 to 1500 msec
These parameters control the tremolo echo times for the left and right side. Higher settings yield
a deeper echo.
EQ TRIM Range: -24 to +0 dB
Allows you to adjust the input volume of the EQs to eliminate the possibility of clipping boosted
signals.
BASS FC Range: 0000 to 1000 Hz
Selects the cutoff-frequency of the lower-frequency band shelving filter.
LEVEL Range: -48 to +24 dB
Sets the amount of boost or cut applied to the low shelving filter.
TREBLE FC Range: 01KHz to 15KHz
Selects the cutoff-frequency of the upper-frequency band high shelving filter.
LEVEL Range: -48 to +24 dB
Sets the amount of boost or cut applied to the high shelving filter.
To Next Page
Loading...
Need help?
General
