Section 11 — Sequencer Parameters TS-12 Musician’s Manual
32
The following are display only parameters, provided here for your information:
Sequence Name
Shows the name of the sequence which is playing as the current song step. This is updated with
the new steps as the song plays.
STEP/REP
Shows your current location in the song by steps and repetitions. You can locate to a different
place in the song using the GOTO function described below.
BAR/BEAT
Shows your location within the current song step by bar and beat. As with the song steps and
reps, you can locate to a different point using the GOTO function.
The user-controllable parameters on the Song Locate page are:
TEMPO Range: -99 to +99 BPM, or EXT
This controls the tempo of the song. It is expressed as a percentage of the sequence tempo —
changing the song tempo offset automatically adjusts the tempo of each the sequences in the song
by +/–99%, within the legal limits of 25-250 BPM. When TEMPO=+00 the sequences will play at
their designated tempo.
When CLOCK=MIDI on the Sequencer Control page, this field will read TEMPO=EXT to indicate
that the tempo is being controlled by incoming MIDI clocks.
GOTO — Song Autolocate control
The GOTO sub-page looks a little different in song mode, as you can locate to any step or rep in
the song, as well as to any bar and beat within the step.
To Next Page
Loading...
Need help?
General
