TS-12 Musician’s Manual Section 13 — Storage
7
RENAME — Changing a Disk's Name
The RENAME function lets you change the seven character Disk I.D. to a new name The disk
name is used to give each of your TS-12 disks a unique identity. The name of a newly formatted
TS-12 disk defaults to TSD-000. Note that you cannot rename a Sampled Sound disk.
• Press Storage and then select DISK.
• Press RENAME. The display shows:
• Select YES to start renaming using the name from the disk in drive as a starting point.
• Select NO to start renaming with your own custom disk name that is currently stored in
memory as a starting point.
• After selecting either YES or NO, the display shows the following:
• Use the Up/Down Arrow buttons to change the first character of the name and the left and
right buttons on the screen to move the cursor to the next character. The last three alpha-
numeric characters can only be numbers. Once you have the name that you want:
• SAVE saves the name shown into memory (battery backed up RAM) as your custom disk
name. This custom disk name is also saved with global parameters when you SAVE SYSTEM
SET-UP (on the Disk Save page). Saving a custom disk name allows you to easily rename and
format a series of disks by simply updating the number portion of the name.
• RENAME will write the name shown above onto the disk in the drive.
• EXIT will abort this process, without changing the disk name.
To Next Page
Loading...
Need help?
General
