TS-12 Musician’s Manual Section 15 — Sampled Sound Parameters
11
Pitch Mods Page
The Pitch Mods page parameters control WaveSample pitch modulation.
Press the Pitch Mods button. The display shows the Pitch Mods page.
Note: When STEREO=ON, all pitch modulation in the right layer will be slaved to the settings in the
WaveSamples assigned to the same or overlapping key zones in the left layer. This includes
BEND Range, NOISE RATE, and all pitch modulation. Pitch modulation settings for
WaveSamples in the right layer will be ignored.
MODSRC Range: various
Selects a modulation source for the pitch of the WaveSample from among the 15 available
modulators.
MODAMT Range: -99 to +99
Determines the amount by which the assigned pitch modulator will affect pitch.
BEND Range: 0 to 12 semitones or SYS
Determines whether each WaveSample will have its own independent pitch bend range, or
whether it will use the system pitch bend range to determine the maximum pitch change that can
be applied by the pitch bend wheel. When BEND=SYS, the WaveSample will use the system
pitch bend range setting. See the description of the PITCH-BEND parameter on the System Page
in Section 2 — System Page Parameters for more information on the system pitch bend range.
NOISE Range: -99 to +99
This parameter controls the amount by which the NOISE modulator will affect pitch.
ENV1 Range: -15.7 to +15.7 semitones
This parameter controls the amount by which ENV1 will affect pitch.
LFO Range: -15.7 to +15.7 semitones
Determines the amount by which the LFO (Low Frequency Oscillator) will affect pitch.
To Next Page
Loading...
Need help?
General
