RAK139_ENG / 2023-09-14
14 / 36
4. Lift the foundation into the installation pit. You can use the attachment bar in the foundation as a
lifting point. Make sure that the mounting bar is in a direction that enables the installation of the
charging station in correct position.
5. Put cable conduits into the trenches and install the conduits to relevant inlets.
6. Pull electric cables through the conduits into the foundation approx. 1500mm measured from the
top of the foundation.
7. Tighten the foundation to its place by lling the excess space outside the foundation with gravel.
8. Set the nal layer of gravel so that the top of the foundation will be ush with ground or the nal
paving material.
9. Always put a cover plate on the foundation, if the charging station is installed in a separate session
than the foundation.
10. Remove the cover plate before you start the installation work.
11. Put the adapter element on the foundation.
12. Attach the adapter element to the foundation at-
tachment bar with bolts 3 pcs (included).
13. Put the mounting pole on the adapter. Tighten with
the washers and nuts included in the delivery.
14. Pull the electrical cables through the mounting pole.
15. Attach the charging station to the mounting pole.
See instructions on page 15.
To Next Page
Loading...
