GMRP Configuration Screen
8-10 GARP Configuration Menu Screens
8.3.2 Setting a Mode for All Ports
The modes of operation are the same as the ones described in Section 8.3.1, except that all ports
are affected. To set all the ports to operate in one mode, proceed as follows:
1. Use the arrow keys to highlight the Set All Ports field.
2. Press the SPACE bar to select one of the following modes of operation:
• Use GMRP Filter Unreg
• Forward All Groups
• Filter All Groups
• Use GMRP Forward Unreg
3. Press ENTER.
4. Use the arrow keys to highlight the SAVE command at the bottom of the screen.
5. Press ENTER. The message “SAVED OK” displays and all ports operate to the mode selected.
To Next Page
Loading...
