General Configuration Screen
Device Configuration Menu Screens 4-5
Screen Example
Figure 4-2 General Configuration Screen
Field Descriptions
Refer to Table 4-2 for a functional description of each screen field.
.
Table 4-2 General Configuration Screen Field Descriptions
Use this field… To…
MAC Address
(Read-Only)
See the base physical address of the SmartSwitch device.
IP Address
(Modifiable)
See the IP address for the SmartSwitch device. To set the IP address,
refer to Section 4.2.1. The IP address can also be set through Runtime
IP Address Discovery.
Runtime IP Address Discovery enables the SmartSwitch device to
automatically accept an IP address from a Boot Strap Protocol (BootP)
server on the network without requiring a user to enter an IP address
through Local Management.
30691_08
MAC Address:
IP Address:
Subnet Mask:
Default Gateway:
TFTP Gateway IP Addr:
Device Date:
Device Time:
Screen Refresh Time:
Screen Lockout Time:
Com: [ENABLED] Application: [LM]
Clear NVRAM: [NO]
Device Uptime XX D XX H XX M
IP Fragmentation: [ENABLED]
Operational Mode: [802.1Q SWITCHING]
00-00-ID-00-00-00
0.0.0.0
255.255.0.0
NONE DEFINED
0.0.0.0
RETURNSAVE
10/11/1999
14:23:00
30 sec.
15 min.
EXIT
To Next Page
Loading...
