Enterasys 2H25x - Flash Download Configuration Screen Field Descriptions

FLASH Download Configuration Screen
4-34 Device Configuration Menu Screens
Field Descriptions
Refer to Table 4-9 for a functional description of each screen field.
Table 4-9 Flash Download Configuration Screen Field Descriptions
Use this field… To…
Download Method
(Selectable)
Select a method (RUNTIME, DOWNLOAD CONFIG, or UPLOAD
CONFIG) to download (receive) an image file from a TFTP server, or
upload (transmit) or download a configuration file to/from a TFTP
server. The uploading and downloading of a configuration file is
accomplished according to the IP address and the file name entered in
the Download Server IP and Download File Name fields, respectively.
RUNTIME – Used to download a new image from a TFTP server.
This allows the replacement of the image file currently stored in the
SmartSwitch device. Section 4.8.1 describes how to download using
Runtime.
DOWNLOAD CONFIG – Used to download a configuration file from
a TFTP server to a SmartSwitch device. The configuration file must be
one that was uploaded to the TFTP server from a SmartSwitch device
of the same model with the same optional hardware, and running
firmware revision 3.10.7 or higher.
The SmartSwitch device automatically reboots after a successful
download. Section 4.8.2 describes how to download a configuration
file.
UPLOAD CONFIG – Used to upload a configuration file from a
SmartSwitch device to a TFTP server. The configuration file must be
one that was downloaded to a SmartSwitch device of the same model
with the same optional hardware, and running firmware revision 3.10.7
or higher.
Section 4.8.3 describes how to download using TFTP.