RMON Statistics Screen
10-12 Device Statistics Menu Screens
10.4.1 Displaying RMON Statistics
To display the statistics for any index, proceed as follows:
1. Use the arrow keys to highlight the Index [nn] field at the bottom of the screen.
2. Press the SPACE bar to increment (or press the DEL [delete] key to decrement) the index
number.
3. Press ENTER (neither the RMON Index field nor the statistics will change until ENTER is
pressed).
65 – 127 Octets
(Read-Only)
See the total number of frames, including bad frames, received that
were between 65 and 127 bytes in length (excluding framing bits, but
including FCS bytes).
128 – 255 Octets
(Read-Only)
See the total number of frames, including bad frames, received that
were between 128 and 255 bytes in length (excluding framing bits, but
including FCS bytes).
256 – 511 Octets
(Read-Only)
See the total number of frames, including bad frames, received that
were between 256 and 511 bytes in length (excluding framing bits, but
including FCS bytes).
512 – 1023 Octets
(Read-Only)
See the total number of frames, including bad frames, received that
were between 512 and 1023 bytes in length (excluding framing bits,
but including FCS bytes).
1024 – 1518 Octets
(Read-Only)
See the total number of frames, including bad frames, received that
were between 1024 and 1518 bytes in length (excluding framing bits,
but including FCS bytes).
Index [nn]
(Command)
Enter an index number for viewing statistics. For instructions on how
to use this command, refer to Section 10.4.1.
CLEAR
COUNTERS
(Command)
Temporarily reset all counters of a screen to zero to allow the user to
observe counter activity over a period of time. For details on how to use
this command, refer to Section 3.1.4.
Table 10-4 RMON Statistics Screen Field Descriptions (Continued)
Use this field… To…
To Next Page
Loading...
