RADIUS Configuration Screen
Accessing Local Management 3-19
Auth Port
(Modifiable)
Enter the number of the Authorization UDP Port for the Primary and
Secondary server.
Acct Port
(Modifiable)
Enter the number of the Accounting UDP Port for the Primary and
Secondary server.
Timeout
(Modifiable)
Enter the maximum time in seconds to establish contact with the
Radius Server before timing out.
Retries
(Modifiable)
Enter the maximum number of attempts (1…N) to contact the Radius
Server before timing out.
Last Resort
Action/Local
(Selectable)
Accept, Challenge, and Reject, which do the following:
ACCEPT: Allows local access (via COM port) at the super-user
level with no further attempt at authentication.
CHALLENGE: Reverts to local module (legacy) passwords.
REJECT: Does not allow local access.
For more details, refer to Section 3.7.1.
To set local and remote servers, refer to Section 3.7.2.
Last Resort
Action/Remote
(Toggle)
Accept, Challenge, and Reject, which do the following:
ACCEPT: Allows remote access (via Telnet or WebWiew) at the
super-user level with no further attempt at authentication.
CHALLENGE: Reverts to local module (legacy) passwords.
REJECT: Does not allow remote access.
For more details, refer to Section 3.7.1.
To set local and remote servers, refer to Section 3.7.2.
Radius Client
(Toggle)
Enable or disable client status.
Table 3-4 Radius Configuration Screen Field Descriptions (Continued)
Use this field… To…
To Next Page
Loading...
