INSTALLATION
Combinat ion Blan ke t/F luid W a rmer ▪ Operato r’s Man ual ▪ M N-399 40 ▪ Rev 3 ▪ 8/ 20
24
Continued from previous page
Position the warmer To position the warmer, do the following.
Step Action
1. Make sure that:
▪ The location where the warmer is being installed is rated to support the
weight of the warmer;
▪ The warmer is within five feet of the appropriate electrical outlet;
▪ You follow the warmer clearance guidelines shown below. Refer to topic
Specification Information for clearance requirements.
▪ You reference the built-in specification page for cutout dimensions
(EC1350BL only).
2. Move the warmer to the installation location and onto the final resting
surface.
3. Lock the casters, if equipped.
The warmer is now correctly positioned.
Mount the warmer to
floor (EC1350BL only)
To mount the warmer to the floor, do the following.
4. Bolt the warmer to the floor.
Continued on next page
WARNING: Tipping hazard.
Mount the EC1350BL to the floor before use.
NOTE: Reference OPM-0562-19 for California seismic conformance.
To Next Page
Loading...
