Entrematic Ditec E2H - Selection and Signals; Selection Settings; Signals

47
IP1967EN - 2016-08-01
7. Selection
8. Signals
Description OFF ON
JR1 Display mode setting. Visualization mode. It is
only possible to visualize
the values and parameters
present.
Maintenance mode. It is
possible to visualize and
modify the values and pa-
rameters present. The en-
try in maintenance mode is
indicated by the permanent
switching on of the right-
hand point.
JR5 Built-in radio receiver. Disabled Enabled
LED ON Flashing
POWER
24 V= power supply. Indicates the transfer of data during
DMCS programming.