Entrematic Ditec E2H - Display Viewing Modes; Automation Status Display; Commands and Safety Devices Display

65
IP1967EN - 2016-08-01
Display Description
Automation closed.
Automation open.
Automation stopped in intermediate position.
Automation closing.
Automation opening.
Automation closing from partial opening.
Automation in partial opening.
Automation partially open.
10. Display viewing mode
10.1 Automation status display
10.2 Commands and safety devices display
i
i
i
WARNING: it is possible that, owing to the type of automation and control panel, certain
menus are not available.
WARNING: the automation status display mode is visible only with the Display viewing mode
set on 02.
WARNING: the commands and safety device display mode is only visible with the Display
viewing mode set on 01 or 03.
Display Description
1-2 - Automatic closing activation command.
1-3 - Opening command.
1-4 - Closing command.