EasyManuals Logo

Entrust nShield Connect Installation Guide

Entrust nShield Connect
73 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
Two independent network interfaces.
You must connect the interfaces to physically different networks.
The two network interfaces combined as a bond interface.
The bond interface can use:
Active backup mode.
802.3ad mode (requires a switch that supports 802.3ad).
You can configure the nShield Connect using the front panel Network config menu, or by
pushing a configuration file to the nShield Connect over the network. The initial set up of
the nShield Connect must be done using the front panel. The following can be
configured:
Interface addresses
Bond
Default gateway
Network routes
Network speed.
If the nShield Connect is already configured, you can update the displayed values.
If you ever change any of the IP addresses on the nShield Connect, you must update the
configuration of all the clients that work with it to reflect the new IP addresses.
By default, the hardserver listens on all interfaces. However, you can
choose to set specific network interfaces on which the hardserver
listens. This may be useful in cases such as if one of the Ethernet
interfaces is to be connected to external hosts. See the User Guide for
more information.
9.2.1.1. IPv4 and IPv6
Support for IPv6 is in addition to IPv4. Both Ethernet interfaces can be configured to
support:
IPv4 only
IPv4 and IPv6
IPv6 only.
Interface#1 is enabled by default and cannot be disabled. Interface #2 is
disabled by default and can be enabled and disabled.
nShield® Connect Installation Guide 27 of 73

Table of Contents

Other manuals for Entrust nShield Connect

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Entrust nShield Connect and is the answer not in the manual?

Entrust nShield Connect Specifications

General IconGeneral
BrandEntrust
ModelnShield Connect
CategoryControl Unit
LanguageEnglish