Enviro E33 - Burner Lighting; Blower Speed; Operating Instructions Operating Instructions

9
Operating InstructionsOperating Instructions
buRneR Lighting:
bLoweR sPeeD:
The blower will come on only when the replace is up to temperature (approximately 15 minutes). The
fan controller knob can be found to the left of the door, behind the surround panel. Rotating the fan
controller knob will change the speed of the fan. To turn the blower off, fully rotate the fan controller
knob counter-clockwise.
Figure 6: E33 Control Panel.
A) Make sure the pilot is lit.
B) Turn gas control knob COUNTER CLOCKWISE to ON.
C) Flip the burner switch to ON (Located on the surround panel).
- An alternate switch location is shown in Figure 6.
D) Turn HI/LO knob to the desired ame height.
E) Turn on all electrical power to the unit.
NOTE: Check that all burner holes are lit.
TO TURN GAS FIREPLACE OFF
Flip the burner switch to OFF to turn off burner only.
If the replace is to be turned off for the season or for servicing, turn control
knob to OFF, turn the gas shut off valve to OFF. DO NOT FORCE IT. If the
unit is going to be serviced, turn off the electrical power to the unit as well.
NOTE: When the unit is turned on for the rst time, it should be turned to
high, with the fan OFF, for the rst four (4) hours. This will cure the paint,
logs, gasket material, and other products used in the manufacturing process.
It is advised that a door or window be opened as the unit will smoke, which
can irritate some people. After the unit has gone through the rst burn,
turn the unit OFF, including the pilot, and let the unit completely cool. Then
remove the door and clean the glass with a good gas replace glass cleaner,
available at your local Enviro dealer. See
maIntenance anD serVIce - cleanIng
the glass and maIntenance anD serVIce - glass Door remoVal.
Alternate Burner Switch Location