Division:
14 I 77
Assembly and installation
Unpacking
All a1-envirosciences products undergo extensive quality control before leaving the factory
and are carefully packed.
After delivery, check the packaging and contents immediately for signs of visible damage due
to improper handling during transport.
Until commissioning by a1-envirosciences, you should keep all components in their
packaging. During installation, all components are unpacked and set up by
a1-envirosciences.
If you unpack the components yourself (not recommended), please ensure that all
accessories are included. Keep the original packaging in any case as it offers optimum
protection if the components have to be returned, for example.
Always lift the ST1 weighing enclosure by grasping it under the base plate.
Never lift it by the arm bar or the side openings.
Otherwise, the arm bar may be damaged or the base plate may detach from
the enclosure.
The ST1 safety weighing enclosure weighs 30-90 kg. There is a risk of injury
when lifting.
It must be moved by two persons or by means of a lifting tool.
Avoid damage to the equipment during handling
To Next Page
Loading...