Division:
26 I 77
Operation
Special safety instructions
The ST1 safety weighing enclosure is designed for personal protection. A
hazard assessment and risk analysis are necessary to ensure the suitability of
the safety weighing enclosure for personal protection. We are happy to support
you in this. Product protection is only ensured if the room air is appropriately
conditioned.
The ST1 safety weighing enclosure does not invalidate the generally applicable
laboratory regulations and the safety regulations in the user's laboratory.
When operating the ST1 safety weighing enclosure, suitable personal
protective equipment (PPE), such as safety goggles, protective gowns,
protective gloves and perhaps protective sleeves, must be worn.
To ensure optimum personal protection, a1-envirosciences recommends
wearing double protective gloves and sleeves in addition to the usual
protective measures.
During work, the front flap must not be opened under any circumstances.
Otherwise, the inflow velocity will fall below the permissible value,
substances may escape and safety is no longer ensured.
The front flap must remain closed during operation and may only be opened
after cleaning has been completed.
Before opening the front flap, it must be decontaminated on the inside and
especially in the bend.
Limits of product and personal protection
Protection against contamination
Personal protective equipment
Only work with the front flap closed
To Next Page
Loading...