Division:
35 I 77
Switching on the alarm system
The alarm system is switched on at the main switch (I) of the electronics box. It is located at
the rear of the safety weighing enclosure (standard design), as described above. This makes
all third-party devices connected to the electronics box (lamp, filter unit, etc.) ready for
operation.
Figure 18 - Electronics box of the alarm unit; front surface
Operating the alarm unit
After pressing the main switch, the standby screen is shown in the display on the top of the
enclosure. By tapping the "ON/OFF" button (II), the alarm system including all connected
peripheral devices is started.
As long as this screen is displayed, connected third-party devices such as the filter unit or
the LED lamp are switched off.
To Next Page
Loading...