Division:
21 I 77
Options
For higher hazard classes, a 2-layer HEPA filter can be used as an additional safety
measure as redundancy.
For special applications, a carbon filter can be inserted into the filter housing instead
of or in addition to the HEPA filter.
Other possible system configurations are described in the following section "System
configurations and accessories".
System dimensions
The ST1 series safety weighing enclosures are available in three different widths. The exact
inner and outer dimensions can be found in the following tables. The dimensions of the filter
unit housing are specified in the table below. The filter unit is connected to the safety
weighing enclosure via a 2.5 m long ventilation hose. For detailed measurements please
check the chapter Technical Data.
ST1 safety weighing enclosure shown on a granite table (left), on a stainless steel table (middle) and as a stand
solution (right)
To Next Page
Loading...