Division:
70 I 77
Standards, technical rules and test
procedures
Observed standards
DIRECTIVE 2006/42/EC OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 17
May 2006 on machinery, and amending Directive 95/16/EC (recast).
EN ISO 12100:2010 Safety of machinery – General principles for design – Risk
assessment and risk reduction (ISO 12100:2010)
EN 60204-1:2006 Safety of machinery – Electrical equipment of machines – Part 1:
General requirements (IEC 60204-1:2005, modified)
The ST1 series complies with the protective measures required by TRGS 500 (Technical
Rules for Hazardous Substances) and is to be regarded as a highly effective extraction
system. It is suitable for personal protection in accordance with EN 14175-3 for fume
cupboards and also complies with the ASHREA 110 standard.
The ST1 series has been tested according to EN 689 and ISPE guidelines with surrogate
substances by the independent German institute InfraServ. The test protocol can be found in
appendix D.
The HEPA filtration system used is certified according to DIN/EN 1822.
The aforementioned standards have been applied in the design and construction and, where
applicable, are referred to in the applicable declarations of conformity.
Work regulations
The following regulations and directives must generally be observed when working in the
laboratory and with equipment from a1-envirosciences:
For Germany:
Occupational Safety and Health Act
Ordinance on Hazardous Substances
Technical Rules for Hazardous Substances
"Safe Working In Laboratories BGI/GUV-I 850-0"
Waste regulations
To Next Page
Loading...