Enviro ST1 - Discharging the Waste Bags

Division:
46 I 77
Discharging the waste bags
For contamination-free discharge of the waste bags, follow the 11 steps below:
1
Prepare the required
work equipment
- Waste bag (1x)
- Rubber band (1x)
2
Remove the rubber
band that secures the
inner bag and close it
tightly without touching
the edges of the waste
system.
3
Press the sealed bag
into the outer bag.
4
Fasten the new waste
bag to the inner edge of
the waste system using
the rubber band.
5
The entire waste bag
should be in the interior
of the ST1 weighing
enclosure.