Envirosight Verisight Pro
+
This also automatically captures a .jpg image which will be displayed on the
survey when created.
NOTE! There is an option in the Setup Menu that allows you to
turn the automatic image capture feature on or off.
Continuing a Survey
17 Either press the Record key.
or
18 The system will automatically start to record when you start
pushing the camera along.
NOTE! The auto start option is used in case you forget to press the
record button again after entering an observation! By relying on
this option may cause you to notice a slight jump in the video
playback!
19 Repeat steps 12 to 18 each time you wish to capture a new observation.
Review a Survey
20 Press the Survey Forms key.
21 Select Review Survey. This will show you each observation you have
entered with the distance displayed along the captured image.
End a Survey
22 Press the Forms key.
23 Select End Survey.
24 Press OK.
25 You will be prompted to Confirm End Survey by pressing Y.
NOTE! It is also possible to replay the last survey by pressing the
Play key. You can now skip to each defect by pressing the
Arrow Up or Arrow Down keys.
Create Report
28 At this stage press the Y key to create a report, or press the Esc key to create
a report later.
98
To Next Page
Loading...