EN-32 Installation and Operating Instructions - EOS Cubo / Cubo Avantgarde
EN Connections
4 Connections
4.1 General instructions for electrical installation
Ensure that electrical installation is performed in compliance with the stan-
dards and legal norms valid in your country.
If a residual current device (RCD) is installed, ensure that there are no units
not belonging to the sauna system which are fused via this RCD.
If the sauna heater has not been used for an extended period of time, the
heater may draw moisture from the ambient air, which, in rare cases, could
lead to the RCD to be tripped. This is a physical process and not a fault on
the part of the manufacturer.
In this case, the heater must be heated by a technician under supervision
which will bypass the RCD function. Once the moisture has escaped from
the heating elements after approx. 10 minutes, the RCD can be integrated
again in the electric circuit.
If the sauna heater will not be used for an extended period of time, we rec-
ommend that you switch on the heater every 6 weeks so that the heating
elements do not accumulate moisture. If, during commissioning, the RCD is
triggered, the electrical installation must be checked again.
The electrician is responsible for properly connecting the heaters; thus, the
manufacturer does not assume liability.
4.2 Connections
The sauna control unit and the heater must be connected as shown in the
circuit diagrams. Please observe the installation and operating instructions
for the control unit and the sticker on connecting in the heater. See also
2.4 Technische Daten, DE-19.
To Next Page
Loading...
Need help?
General
