EN-40 Installation and Operating Instructions - EOS Cubo / Cubo Avantgarde
EN Maintenance
6.3 Replacing the heating elements
Individual heating elements can be replaced. To remove the heating ele-
ments, the terminal box must be accessible. Furthermore, the cover and
the stones must be removed.
Hardware and tools:
Tubular heating element and/or heating coil
Screwdriver
Hex key
Ring or socket spanner
Preparing the heater
1 WARNING! Electric shock may occur if the heating coil is serviced while
the heater is connected to the power supply.
Ensure that the heater has been disconnected from all power supply
lines.
a) Switch off the heater.
b) Switch off the fuses to disconnect the heater from the mains supply.
2 Remove the heater guard rail.
3 CAUTION! Allow the heater to cool sufficiently before starting work.
Remove the stones.
To Next Page
Loading...
