EOS Cubo / Cubo Avantgarde - Installation and Operating Instructions EN-45
Maintenance
6.4 Resetting the safety temperature limiter
The heater has a dedicated safety temperature limiter to prevent the
heater from overheating.
It only monitors the temperature of the heater. The safety temperature lim-
iter in the temperature sensor monitors if the cabin has overheated.
Resetting the safety temperature limiter
1 CAUTION! Allow the heater to cool sufficiently before starting work.
Use a screwdriver or a coin to unscrew the protective cap (C).
The safety temperature limiter is located below the terminal box and
is accessible from the outside.
2 Press in the pin (B) of the safety temperature limiter until it audibly en-
gages.
If the pin does not click into place, the heater has not cooled down
fully.
3 Re-install the black cap and tighten it.
4 Use the control unit to switch on the heater.
A Safety temperature limiter B Reset pin
C Protective cap
A
B
C
To Next Page
Loading...
