EN-44 Installation and Operating Instructions - EOS Cubo / Cubo Avantgarde
EN Maintenance
Reassembling the heater
1 Push the heating coil back into the heater.
2 Reattach the base and tighten the 4 self-tapping screws.
3 Attach the terminal box cover and secure with 4 screws.
4 Place the heater upright and push it back into its previous position.
5 Reattach the design cover and screw it in place.
6 Reattach the heater guard rail.
7 Insert the stones together with the rock store frame and quartz stones if
applicable.
Check the stones as you work and replace any damaged ones.
8 Switch on the fuses for the heater to connect it to the mains supply.
To Next Page
Loading...
