EOS Cubo / Cubo Avantgarde - Installation and Operating Instructions EN-21
Installation
3 Installation
Prior to installation, air inlets and outlets must be installed in the cabin. All
protective films must be removed.
The supplied protective grill must be mounted above the heater. This pre-
vents objects from falling onto the heater.
3.1 Specifications for the cabin
The cabin must be planned and installed according to specifications before
the heater is installed.
The floor on which the heater stands must be level.
In general, it should be noted that the sauna heater must not be set on a
floor made of highly flammable material (laminate, synthetic flooring, etc.).
Ceramic tiles are recommended as a flooring option.
Electrical lines
All electrical installations laid inside the cabin must be suitable for silicone
cables and a temperature of at least 170°C/338°F. All lines must be routed
in such a way that they are well-protected, e.g., in a cable duct.
If single-core lines are used as connecting cables, they must be protected
by a flexible metal hose that is connected to the protective conductor.
3.1.1 Installation site
The required cabin volume depends on the heater power. See
2.4 Technical data, EN-17.
The clearance distances between the heater and flammable material
(wood wall, sauna bench, etc.) must be observed as shown below.
Dimensions and clearances for Cubo, EN-22
Dimensions and clearances for Cubo Avantgarde, EN-23
To Next Page
Loading...
Need help?
General
