EN-26 Installation and Operating Instructions - EOS Cubo / Cubo Avantgarde
EN Installation
3.2 Heater guard rail
CAUTION
Risk of burns if heater is touched
The outer casing of the heater may become hot and, if touched,
could cause burns.
A heater guard rail must be installed.
You can obtain a suitable heater guard rail from the manufacturer of the
sauna heater.
3.3 Installing the heater
Once the cabin is prepared, the heater is placed on a pre-defined position.
Two people should always carry the heater.
Connecting the connecting cable to the heater, EN-26
Connecting the heater safety temperature limiter, EN-28
Setting up the heater, EN-29
3.3.1 Installing the connecting cable
The terminal box with the connection terminals for the heating elements is
located at the front of the heater.
Connecting the connecting cable to the heater
1 CAUTION! The heater weighs a min. of 20 kg/44 lbs. Two people should
always move the heater.
Unpack the heater and remove all transport locks.
2 Place the heater in the cabin.
To Next Page
Loading...
Need help?
General
