EN-28 Installation and Operating Instructions - EOS Cubo / Cubo Avantgarde
EN Installation
5 Pull the cable through the cable feed opening (C) from below.
6 Connect the cable to the connection terminals (A) in accordance with
the circuit diagram.
Observe the circuit diagram in the terminal box:
7 Tighten all terminals properly.
Connecting the heater safety temperature limiter
1 Secure the connecting cable for the heater safety temperature limiter
within sheathing such as a flexible cable conduit.
The sheath must extend from the cabin wall to the heater.
A Connection terminals B Tubular heating element
C Cable feed opening
A Screws on the cover of the safety
temperature limiter
B Cable feed opening
A
B
C
C
A
B
To Next Page
Loading...
