EN-46 Installation and Operating Instructions - EOS Cubo / Cubo Avantgarde
EN Maintenance
6.5 Troubleshooting
Error Reason Solution
It takes the heater a
long time to heat up
the cabin.
One or more than one
heating element is defec-
tive.
Have a technician replace
the tubular heating ele-
ment.
There is not enough
space between the
stones.
Reshuffle the stones. See
Reshuffling the sauna
stones, EN-39
There is insufficient venti-
lation.
Install the air inlets. If these
are insufficient, add a fan to
the openings. See
3.1.3 Air inlets and
outlets, EN-25
The electrical connection
is defective.
Check the installation fuses.
Have the control unit's out-
puts checked by a techni-
cian.
The position of the tem-
perature sensor is not
optimal.
Check the position of the
temperature sensor and
adjust as needed. See
3.1.2 Temperature sensor,
EN-24
The heater is very hot
but cannot distribute
the heat throughout
the cabin.
There is not enough
space between the
stones.
Reshuffle the stones. See
Reshuffling the sauna
stones, EN-39
To Next Page
Loading...
Need help?
General
