To Next Page

To Previous Page

Important Safety Instructions

Please reserve this manual for future review.

This manual contains all safety, installation, and operation instructions for the Tracer-AN

series MPPT solar controller ("controller" referred to in this manual).

 Read all the instructions and warnings carefully in the manual before installation.

 No user-serviceable components inside the controller; please do not disassemble or

attempt to repair the controller.

 Mount the controller indoors. Avoid exposure to the components and do not allow

water to enter the controller.

 Install the controller in a well-ventilated place; the controller's heat sink may become

very hot during operation.

 It is suggested to install appropriate external fuses/breakers.

 Make sure to switch off all PV array connections and the battery fuse/breakers before

controller installation and adjustment.

 Power connections must remain tight to avoid excessive heating from a loose

connection.

Explanation of symbols

 To enable users to use the product efficiently and ensure personal and property safety,

please read related literature accompanying the following symbols.

 Please read the literature accompanying the following symbols.

Tips: Indicate recommendations that can be referred to.

IMPORTANT: Indicates a critical tip during the operation, if ignored, may cause the

device to run in error.

CAUTION: Indicates potential hazards, if not avoided, may cause the device

damaged.

WARNING: Indicates the danger of electric shock; if not avoided, it would cause

casualties.

WARNING HOT SURFACE: Indicates the risk of high temperature, if not avoided,

would cause scalds.

Epever Tracer AN series User Manual

Questions and Answers: