Epever Tracer AN series - Setting Configuration

23
3） Error codes
Status
Faults
Indicator
Charging
indicator
Symbol
Instruction
Battery over
discharged
Red ON
solid
--
Battery level shows empty,
battery frame blink, fault
icon blink.
Battery over
voltage
Red
Slow
flashing
--
Battery level shows full,
battery frame blink, fault
icon blink.
Battery over
heating
Red
slowly
flashing
--
Battery level shows current
value, battery frame blink,
fault icon blink.
Controller
over
temperature
Red
slowly
flashing
Green
slowly
flashing
Battery level shows current
value, battery frame blink,
fault icon blink.
System
voltage error
Red
slowly
flashing
Fast
flashing in
green
Battery level shows current
value, battery frame blink,
fault icon blink.
3.4 Setting
1) Clear the generated energy
In the PV power interface, long-press the "ENTER" button until the value flashes. Then it
enters the reset mode; press the "ENTER" button again to confirm and reset.
2) Switch the battery temperature unit
In the battery temperature interface, long-press the "ENTER" button to switch the unit.
3) Battery type
① Support battery types
Lead-acid battery
Sealed(default)
Gel
Flooded
User
Lithium battery
LiFePO4(4S/12V;8S/24V;16S/48V)
Li(NiCoMn)O2 (3S/12V;6S/24V;12S/48V)
User