Using the Control Panel 183
EPSON AcuLaser C3800 User's Guide
FontSource
Sets the default font source.
Font Number
Sets the default font number for the default font source. The available number depends on
the settings you made.
Pitch
Specifies the default font pitch if the font is scalable and of fixed-pitch. You can select from
0.44 to 99.99 cpi (characters per inch), in 0.01-cpi increments. This item may not appear
depending on the Font Source or Font Number settings.
Height
Specifies the default font height if the font is scalable and proportional. You can select from
4.00 to 999.75 points, in 0.25-point increments. This item may not appear depending on
the Font Source or Font Number settings.
SymSet
Selects the default symbol set. If the font you selected in Font Source and Font Number is
not available in the new SymSet setting, the Font Source and the Font Number settings are
automatically replaced with the default value, IBM-US.
Form
Selects the number of lines for the selected paper size and orientation. This also causes a
line spacing (VMI) change, and the new VMI value is stored in the printer. This means that
later changes in the Page Size or Orientation settings cause changes in the Form value,
based on the stored VMI.
CR Function, LF Function
These functions are included for users of particular operating systems, such as UNIX.
Tray Assign
Changes the assignment for the paper source select command. When 4 is selected, the
commands are set as compatible with the HP LaserJet 4. When 4K is selected, the
commands are set as compatible with the HP LaserJet 4000, 5000, and 8000. When 5S is
selected, the commands are set as compatible with the HP LaserJet 5S.
To Next Page
Loading...
Need help?
General