Using the PostScript Printer Driver 150
EPSON AcuLaser C3800 User's Guide
Chapter 6
Using the PostScript Printer Driver
About the PostScript 3 Mode
Hardware requirements
Your printer must meet the following hardware requirements to be able to use the
PostScript 3 printer driver.
Memory requirements for using the PostScript 3 printer driver are shown below. Install
optional memory modules into your printer if the amount of memory currently installed does
not meet your printing needs.
System requirements
Your computer must meet the following system requirements to be able to use the Adobe
PostScript 3 printer driver.
For Windows
To use the Adobe PostScript 3 printer driver, your computer must be running Microsoft
Windows XP, XP x64, Me, 98, or 2000. See the following table for details.
Windows XP, XP x64, or 2000
There are no restrictions for these systems.
Windows Me or 98
Recommended memory
512 MB
(for duplex printing of image data in full color at 1200 dpi)
Minimum Recommended
Computer i386, i486, or Pentium processor i486 or Pentium processor
Hard Disk 6 MB free (for driver installation) 8 MB free (for driver installation)
To Next Page
Loading...
Need help?
General