11
At the time of purchase, the batteries are not installed into the remote control.
Insert the batteries provided with this unit, before use.
Push in the catch on the rear of the remote control, then lift it
upwards.
Insert the batteries in their correct polarity.
Close the battery cover.
Preparing the Remote Control
QTip:
If delays in the responsiveness of the remote control occur, or if it does not
operate after it has been used for some time, it probably means that the
batteries are becoming flat. Replace the batteries.Have two spare AA-size
(SUM-3) batteries ready to use when required.
QTip
Avoid allowing direct sunlight or fluorescent light to fall on the remote
control light-receiving area of this unit.The signal from the remote control
may not be able to be received.
Inserting the batteries
v
v
1
2
v
1
v
2
v
3
Remote control usage range
7 m7 m
Approx. 30°
Approx. 30°
Approx. 30°
Approx. 30°
7 m7 m
Approx. 15°
Approx. 15°
Approx. 15°
Approx. 15°
Operable range (horizontal)
Operable range (vertical)
To Next Page
Loading...
