Epson DS-770 II - Page 51

Placing Irregular Shaped Originals
1.
Open the input tray and extend the input tray extension. Slide out the output tray, extend the output tray
extension, and then raise the stopper.
2.
Slide the edge guides on the input tray all the way out.
3.
Place the Carrier Sheet with the illustration on the front edge facing up and place the original in the center of
the Carrier Sheet with the side to be scanned facing down.
Specications of Originals and Placing Originals > Placing Originals > Irregular Shaped Originals
51