Attention
• If you use a USB hub, operation may not be performed correctly. Devices such as digital cameras and USB devices should be connected to the projector directly.
• When connecting and using a USB-compatible hard disk, make sure you connect the AC adaptor supplied with the hard disk.
• Connect a digital camera or hard disk to the projector using a USB cable supplied with or specified for use with the device.
• Use a USB cable less than 3 m in length. If the cable exceeds 3 m, Slideshow may not function correctly.
Removing USB devices
After finishing projecting, remove USB devices from the projector. For devices such as digital cameras or hard disks, turn off the device and then remove it from
the projector.
Connecting a microphone
You can output microphone audio from the projector's speaker by connecting a commercially available dynamic microphone.
a
• Plug-in-power is not supported.
• Adjust Mic Input Level if the microphone audio is difficult to hear, or if it is too loud resulting in a crackling sound.
s Settings - Mic Input Level p.63
• Make the following settings to output audio from a microphone when the projector is turned off.
Set Standby Mode to Communication On. s Extended - Standby Mode p.64
Set Standby Microphone to On. s Extended - Standby Microphone p.64
Connecting Equipment
23
To Next Page
Loading...
Need help?
General
