Sub-menu Function
AMX Device Dis-
covery
When the projector is connected to a network, set this to On to
allow the projector to be detected by
AMX Device
Discovery
g
.Set this to Off if you are not connected to an
environment controlled with a controller from AMX or AMX
Device Discovery.
Crestron Room-
View
Set this to On only when monitoring or controlling the projector
over the network using Crestron RoomView
®
. Otherwise, set
this to Off.
s "About Crestron RoomView
®
" p.114
When this is set to On, the following functions are not available.
• Web control
• Message Broadcasting (EasyMP Monitor Plug-in)
Bonjour
Set this to On when connecting to the network using Bonjour.
See Apple's Web site for more information on the Bonjour
service.
http://www.apple.com/
Reset menu
Resets all of the network settings.
Sub-menu Function
Reset network
settings.
To reset all of the Network settings, select Yes.
Info Menu (Display Only)
Lets you check the status of the image signals being projected and the status
of the projector. Items that can be displayed vary depending on the source
currently being projected. Depending on the model used, some input
sources are not supported.
List of Functions
74
To Next Page
Loading...
