Epson EB-435W - Changing the Aspect Ratio of the Projected Image

Changing the Aspect Ratio of the Projected Image
You can change the Aspect Ratio g of the projected image to suit the type,
the ratio of height and width, and the resolution of the input signals.
Available Aspect Modes vary depending on the image signal currently being
projected.
Changing methods
Each time you press the [Aspect] button, the Aspect Mode name is
displayed on the screen and the aspect ratio changes.
Remote control
a
You can set the aspect ratio from the Configuration menu.
s Signal - Aspect p.61
Changing the aspect mode (EB-435W/EB-425W only)
Projecting images from video equipment or from the HDMI port
Each time the [Aspect] button on the remote control is pressed, the aspect
mode changes in the order Normal or Auto, 16:9, Full, Zoom, and
Native.
Example: 1080p signal input (resolution: 1920x1080, aspect ratio: 16:9)
A
Normal or Auto
B
16:9
C
Full
D
Zoom
E
Native
Projecting images from a computer
The following shows projection examples for each aspect mode.
Aspect mode Input Signal
XGA 1024X768(4:3) WXGA 1280X800(16:10)
Normal
Adjusting Projected Images
40