Switching to the Target Image Using the Remote
Control
You can change directly to the target image by pressing the following
buttons on the remote control.
Remote control
A
Each time the button is pressed, it cycles through the following images:
• Computer1 port
• Computer2 port
B
Each time the button is pressed, it cycles through the following images:
• S-Video port
• Video port
• HDMI port
C
Changes to the images projected with EasyMP Network Projection. When
projecting using the optional Quick Wireless Connection USB Key, this
button switches to that image.
D
Each time the button is pressed, it cycles through the following images:
• USB Display
• Images from the device connected to the USB(TypeA) port
Projecting with USB Display
You can use the commercially available USB cable to connect the projector
to a computer to project images from the computer.
You can send the computer's audio with the projected image.
System requirements
For Windows
OS
Windows 2000
*1
Windows XP
*2
Professional 32 bit, Home Edition 32
bit, Tablet PC Edition 32 bit
Windows Vista Ultimate 32 bit, Enterprise 32 bit,
Business 32 bit, Home Premium 32
bit, Home Basic 32 bit
Windows 7 Ultimate 32/64 bit, Enterprise 32/64
bit, Professional 32/64 bit, Home
Premium 32/64 bit, Home Basic 32
bit, Starter 32 bit
CPU
Mobile Pentium III 1.2 GHz or faster
Recommended: Pentium M 1.6 GHz or faster
Amount of
Memory
256 MB or more
Recommended: 512 MB or more
Hard Disk
Free Space
20 MB or more
Display
Resolution of no less than 640x480 and no higher than
1600x1200.
Display color of 16-bit color or greater
*1 Service Pack 4 only
*2 Except for Service Pack 1
Projecting images
30
To Next Page
Loading...
Need help?
General
