e
Using the [ ], [ ], [ ], and [ ] buttons on the remote
control, or the [
], [ ], [Wide], and [Tele] buttons on the
control panel, correct the position of the corner.
When you press the [
] button, the screen shown in step 4 is
displayed.
If the message "Cannot adjust any further." is displayed while
adjusting, you cannot adjust the shape any further in the direction
indicated by the gray triangle.
f
Repeat procedures 4 and 5 as needed to adjust any remaining
corners.
g
When you are done, press the [Esc] button to exit the correction
menu.
Because Keystone was changed to Quick Corner, the corner
selection screen from step 4 is displayed when you press the [
]
and [
] buttons on the control panel next time. Change Keystone
to H/V-Keystone if you want to perform horizontal and vertical
correction using the [
] and [ ] buttons on the control panel.
s Settings - Keystone - H/V-Keystone p.63
Adjusting Projected Images
36
To Next Page
Loading...
Need help?
General
