Check Remedy
Are the contents of the moving image you are trying to project
copyright protected?
The projector may not be able to project copyright protected moving images that are being played back on a computer.
For more details, see the user's guide supplied with the player.
Projection stops automatically
Check Remedy
Is Sleep Mode set to On?
Press the [
] button on the remote control or the [
t
] button on the control panel to turn on the projector. If you do not
want to use Sleep Mode, change the setting to Off.
s Extended - Operation - Sleep Mode p.78
Is A/V Mute Timer set to On?
Press the [ ] button on the remote control or the [
t
] button on the control panel to turn on the projector. If you do not
want to use A/V Mute Timer, change the setting to Off.
s Extended - Operation - A/V Mute Timer p.78
The message "Not supported" is displayed
Check Remedy
Is the image signal format setting correct?
(Only when projecting images from a video source)
Change the setting according to the signal for the connected equipment.
s Signal - Video Signal p.75
Do the image signal resolution and the refresh rate correspond to the
mode?
(Only when projecting computer images)
Refer to the computer's documentation for how to change the image signal resolution and the refresh rate output from
the computer.
s "Supported Monitor Displays" p.144
The message "No Signal" is displayed
Check Remedy
Are the cables connected correctly? Check that all the cables required for projection are securely connected.
Check that no cables are disconnected and that there are no poor contacts in the cables.
Is the correct port selected? Press the [Search] button or the [Source Search] button to change the image.
s "Automatically Detect Input Signals and Change the Projected Image (Source Search)" p.38
Problem Solving
101
To Next Page
Loading...
Need help?
General
