a
• Make the following settings to output image and audio even when the projector is in standby mode.
Set Standby Mode to Communication On.
s
Extended - Standby Mode p.78
Set A/V Output to Always On.
s Extended - A/V Settings - A/V Output p.78
• When the audio cable jack is inserted into the Audio Out port, audio stops being output from the projector's built-in speakers and switches to external
output.
Connecting a LAN Cable
Connect a LAN port on network hubs or other equipment to the projector's LAN port with a commercially available 100BASE-TX or 10BASE-T LAN
cable.
By connecting a computer to the projector over a network, you can project images and check the status of the projector.
LAN
The position of the LAN port differs depending on the model being used. s "Interface" p.9
a
To prevent malfunctions, use a category 5 or higher shielded LAN cable.
Connecting Equipment
33
To Next Page
Loading...
Need help?
General
