Soft keyboard operations
The Network menu contains items that require input of alphanumerics
during setup. In this case, the following software keyboard is displayed. Use
the [
][ ][ ][ ] buttons to move the cursor to the desired key, and
then press the [
] button to enter the selected character. Enter figures by
holding down the [Num] button on the remote control, and pressing the
numeric buttons. After inputting, press Finish on the keyboard to confirm
your input. Press Cancel on the keyboard to cancel your input.
• Each time the CAPS key is selected and the [ ] button is pressed, it
sets and changes between upper case and lower case letters.
• Each time the SYM1/2 key is selected and the [
] button is pressed, it
sets and changes the symbol keys for the section enclosed by the frame.
The following types of character can be entered.
Numbers
0123456789
Letters
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
Symbols
! # $ % & ' ( ) + - . / < = > ? @ [ ¥ ] ^ _ { | } ~
a
• You cannot use colons (:) for Network menu items.
• Except for SSID, you cannot use spaces for Network menu items.
• The following four characters cannot be entered using the soft
keyboard. Enter these characters using a Web browser.
“ * , ;
s
"Changing Settings Using a Web Browser (Web Control)"
p.127
Basic menu
Submenu Function
Projector Name
The projector's name is displayed when using the supplied
application EasyMP Network Projection.
When editing, you can enter up to 16 single-byte alphanumeric
characters.(" * + , / ; < = > ? [ ¥ ] ` | cannot be used.)
List of Functions
83
To Next Page
Loading...
Need help?
General
