Automatically Detect Input Signals and Change
the Projected Image (Source Search)
Press the [Search] button on the remote control or the [Source Search]
button on the control panel to project images from the port currently
receiving an image.
Using the remote control Using the control panel
When two or more image sources are connected, press the [Search] button
on the remote control or the [Source Search] button on the control panel
until the target image is projected.
When your video equipment is connected, start playback before beginning
this operation.
a
The following screen is displayed while no image signals are input.
Projecting Images
38
To Next Page
Loading...
Need help?
General
