Submenu Function
Address 1 Set-
ting/Address 2
Setting/Address
3 Setting
Enter the destination email addresses to which to send the
notification email, and select the problems or warnings you want
to be notified about. You can register up to three destinations.
You can enter up to 64 single-byte alphanumeric characters for
the email addresses.( " ( ) , ; < > [ ¥ ] cannot be used.)
You can enter up to 32 characters on the Configuration menu.
When entering more than 32 characters, use your Web browser
to enter the text.
s "Changing Settings Using a Web Browser (Web Control)"
p.127
The address for destination 1 is the mail notification sender's
address.
Others menu
Submenu Function
SNMP
Set to On to monitor the projector using
SNMP
g
. To monitor
the projector, you need to install the SNMP manager program on
your computer. SNMP should be managed by a network
administrator. The default value is Off.
Trap IP Address
1/Trap IP Ad-
dress 2
You can register up to two IP addresses for the SNMP trap
notification destination.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from
0 to 255)
Priority Gateway
For the priority gateway, select either Wired LAN or Wireless
LAN.
AMX Device Dis-
covery
When you want to allow the projector to be detected by
AMX
Device Discovery
g
, set this to On. Set this to Off if you are not
connected to an environment controlled by a controller from
AMX or AMX Device Discovery.
List of Functions
89
To Next Page
Loading...
Need help?
General
