a
If the [Esc] button is pressed for at least 2 seconds, the confirm
default reset screen is displayed.
Select Yes to reset the result of Quick Corner corrections.
e
Use the [ ], [ ], [ ], and [ ] buttons to correct the position of
the corner.
When you press the [
] button, the screen shown in step 4 that
allows you to select the area to be corrected is displayed.
If the message "Cannot adjust any further." is displayed while
adjusting, you cannot adjust the shape any further in the direction
indicated by the gray triangle.
f
Repeat procedures 4 and 5 as needed to adjust any remaining
corners.
g
When you are done, press the [Menu] button to exit the correction
menu.
Arc Correction
a
Press the [Menu] button while projecting.
b
Select Geometric Correction from Settings.
c
Select Arc Correction, and then press the [ ] button.
If the message "If this setting is changed, the image may be
distorted." is displayed, press the [
] button.
d
Use the [ ], [ ], [ ], and [ ] buttons to select the area you
want to adjust, and then press the [
] button.
When selecting a corner, you can adjust the two sides next to the
corner.
a
If the [Esc] button is pressed for at least 2 seconds, the confirm
default reset screen is displayed.
Select Yes to reset the result of Arc Correction.
e
Use the [ ], [ ], [ ], and [ ] buttons to adjust the shape.
Adjusting Projected Images
42
To Next Page
Loading...
Need help?
General
